by middl2cj | Oct 23, 2018 | Uncategorized
Cam and I decided to fix the bottom part of the broken colander. The colander was supposed to have three legs to it, but one broke off and the colander was at an angle 24/7. First, we needed to decide what kind of design we would do, and at first Professor Field...
by freemael | Oct 23, 2018 | Uncategorized
Yaseem and I chose David’s broken coaster to fix. We decided the best way to do that was to make a case that it can sit it. So we measured it to where it sit in it perfectly. We wanted to jazz it up a little so we added some words on it to remind David not to break it...
by wisharns | Oct 23, 2018 | Uncategorized
David and I fixed the problem with the power button on a wii remote. It was broken because it was hard to press the power button for it to turn on. The button would only work if you pressed it in a certain spot, but fingers were too large to press the button in that...
by Ashley J | Oct 23, 2018 | Uncategorized
We (Me and Lindsey) fixed the mug with the broken handle. Here is a picture before. We decided to make a handle that was more unique and modern, one that was only connected on the top. It took us a few prints to get this right with the measurements of the hole. We...
by maourynd | Oct 22, 2018 | Uncategorized
For our fix-it project, we chose a toothpaste squeezer. The goal of this creation was to have something that can be put on a tube of toothpaste to squeeze the tube. As you can see here, we created one in the shape of a pumpkin: After our first print, we made a second,...
by Ben | Oct 21, 2018 | Uncategorized
The fix we chose to take on for class was a missing zipper on a toiletry bag for Cam. We looked through a bunch of designs through thingiverse and found one a print that clipped around a paperclip which went into the space of the zipper. We added some customization to...
by RyanK | Oct 17, 2018 | Uncategorized
For our Fix It! project design, we chose to tinker the cap to an Apple Pencil. This design came to our attention by Nic and his request to receive a new top piece to his beloved Apple Pencil. It was a little difficult creating this project due the fact that it is so...
by Vicky Orlin | Oct 17, 2018 | Uncategorized
For the class challenge we decided to make the stand and holder for the expo markers. The design itself was not hard to come up with, but we had ensure the dimensions were correct. Within this area we would measure the expo markers themselves to ensure they would...
by dinsx | Oct 17, 2018 | Uncategorized
For the ring project, I ran into a lot of trouble in MeshMaker and first made only a simple design in Fusion 360 and printed it. Once I understood the meshing process better, I made a new design with a bear head and paw stencils. UPDATE: Here is the ring that I...
by RyanK | Oct 17, 2018 | Uncategorized
I first started by using Fusion 360 and test printed some rings just to see what size will fit my finger must comfortably. I test printed around 5 rings to finally coming down to two rings that I liked. One of them is a little bit tighter on my ring finger and the...
Recent Comments