by meadorjn | Oct 24, 2018 | Uncategorized
For our fix it project we chose to fix the broken cat toy. The toy is broken and can not be held out straight for optimum cat fun. So we decided to print tubes over top of the 2 broken sections. We do this by stopping the print half way and placing the cat toy onto...
by NicoleP | Oct 23, 2018 | Uncategorized
Hello! For our project we chose to “fix” a microphone in need of stand. The print took a bit of time, however I think we can call it a success! The stand is a layered cylinder – the larger of which hugs the base of the microphone. The smaller...
by Tony Pau | Oct 23, 2018 | Uncategorized
We decided to replace a crayon box that holds cards with a box of our own. The 3D print consists of 2 parts made in the Fusion 360. One of them which is the box itself is used to hold the playing cards while the other part is a little slider that keeps the cards...
by freemael | Oct 23, 2018 | Tinkercad Design Project
We chose to do a water bottle for our tinkered design project! It’s a very basic water bottle with a screw top lid. We just used a cylinder for the main structure and used a hole screw instead of solid screw. Then for the lid we used a solid screw on a smaller...
by moritzms | Oct 23, 2018 | Uncategorized
Morgan Moritz Carissa Showalter We had the challenge to Fix the small ruler. The ruler had a slit that went right through it and the owner of the ruler didn’t like the size of the ruler. Thus, our challenge was to fix these aspects of the ruler. We set out to make a...
Recent Comments