by freemael | Sep 18, 2018 | Tinkercad Design Project
After deciding that we needed to try printing it sideways before changing the design, we tested it out. It turned out much better than what we expected (for the lid at least). We printed it at 70% instead of 100% and the support didn’t mess up the handle on the...
by freemael | Sep 18, 2018 | Tinkercad Design Project
Our initial print didn’t turn out as we expected. The support needed for the screws is incredibly troublesome. The screws themselves did not turn out how they were supposed to — they were much thinner than they are in tinkercad. We just tested it with half...
by dunnlm | Sep 18, 2018 | Tinkercad Design Project
We (Ashley and Lindsey) reprinted our tree without support and it was a success! We then decided to test print just our building in two different positions. We first printed it standing up normal and then laying on its back. You can see that laying on its back printed...
by Joanie | Sep 18, 2018 | Tinkercad Design Project
We are trying to make a plant holder with removable legs to have the planter either “sit” or stand.” Here is the first print experimenting with varies different leg joints and connected found in TinderCad: We found that most of the joints and...
by Joanie | Sep 18, 2018 | Uncategorized
We are trying to make a fancy plant holder. We figured that the hardest part of this project would be to make legs that would be able to have the planter “sit” or “stand.” So we decided to experiment with different way to hold the planter up...
by middl2cj | Sep 18, 2018 | Tinkercad Design Project
As seen in our first post, we have the orange support beams going through the middle of our design, but we’re a little bit skeptical of how that will work. We might have to eliminate the beams to allow the catapult to work effectively, but we are still in the...
by middl2cj | Sep 18, 2018 | Tinkercad Design Project
At first we decided that we wanted to make an interactive chess board that someone could actually use, then we had the idea of making a moving truck/car, but we wanted to go more outside the box so we decided to make/design a working catapult. Here, we have our...
by showalca | Sep 18, 2018 | Tinkercad Design Project
Carissa Showalter Morgan Moritz First Design Iteration We chose to do a speaker because it is fun, functional and three dimensional. The design is simple and doesn’t take up much space. The main box is three dimensional with a hollow slit at the top that can fit...
by loughjp | Sep 17, 2018 | Uncategorized
First Draft We chose to do a chessboard with the necessary chess pieces. The board is a relatively easy design that the only adjustment we will have to make is to paint it the right colors. The pieces themselves were a little hard to make in Tinkercad just due to...
by khadkacr | Sep 17, 2018 | Tinkercad Design Project
First Draft Print – Pictured above are our first draft sketches of the fidget spinner we’re creating. We learned that in order for a fidget spinner to keep momentum while cycling around, the spinner needs to have somewhat of symmetrical wings. We also...
Recent Comments