by RyanK | Dec 10, 2018 | Uncategorized
The first thing we printed in class was during Tinkercad. We printed a Coin Trap Then from the hat I grabbed “Fountain” so this was my take on JMU fountain that we have near the sundial. I do not have the possession of the fountain anymore but this was my...
by RyanK | Dec 9, 2018 | Uncategorized
On 12/08 I had the opportunity to go to the Children’s Museum located in downtown Harrisonburg. I was there for two hours from 1 – 3 PM. Only kids from age 8 and up were allowed to work on the 3D printing with the supervision of their parents. At the...
by RyanK | Dec 5, 2018 | Uncategorized
I was always a big fan of Supreme skateboard company’s products. I was never able to afford any of their products because they are very very expensive so I thought it was a good idea for my final project to tinker my own version of Supreme key chain. I made two...
by RyanK | Oct 17, 2018 | Uncategorized
For our Fix It! project design, we chose to tinker the cap to an Apple Pencil. This design came to our attention by Nic and his request to receive a new top piece to his beloved Apple Pencil. It was a little difficult creating this project due the fact that it is so...
by RyanK | Oct 17, 2018 | Uncategorized
I first started by using Fusion 360 and test printed some rings just to see what size will fit my finger must comfortably. I test printed around 5 rings to finally coming down to two rings that I liked. One of them is a little bit tighter on my ring finger and the...
Recent Comments