by middl2cj | Sep 25, 2018 | Tinkercad Design Project
First Blog Post (Design Project): Hey! Our names are Cam and Cam, and to start we wanted to make a chess board with actual pieces that you could move. However, after some thought we decided that we should go the route of a fire truck/car. We want the truck/cars...
by buschmh | Sep 19, 2018 | Uncategorized
Over the past week, we have updated our design to include a “slide-close” door as opposed to a swing shut door. Additionally, we have changed the dimensions and made them larger so that they better fit over top of out-of-wall outlets. We also added a fun...
by buschmh | Sep 19, 2018 | Uncategorized
From this first test print, we learned that our planned dimensions were a tad small. Additionally, we learned that our door flip design is not very practical, as it swings, comes loose, and falls off fairly easily. The overall idea and design has potential with...
by herlickb | Sep 19, 2018 | Tinkercad Design Project
FIRST DRAFT PRINT The first print of our chess piece turned out pretty well, the holes/squares in the chess piece came out well except in the back where it was being printed/supported. Since we wanted to ensure that the holes came out well, we rotated the chess piece...
by Somer Medawar | Sep 19, 2018 | Uncategorized
Our original design for the planter needed a base that would configure in the same shape as the mountain range shape. The first print was small, which we expected based on how big it was on the plane in Tinkercad, but there is plenty of room for improvement! The walls...
Recent Comments