I printed a boat for my final project. It came out very well and except for some support removal accidents, everything came out connected. I did have to glue the chair back into the console and the fishing rods broke off when I was removing support underneath the engine, but it looks fine after I glued them back on. This process took a lot of time, first designing and then test printing the boat. I tried printing it first small and it came out successfully in about 3 hours, but it was harder to get the support out from a smaller piece. Printing it the size it is now took 16 hours but it came out nicely, and the lettering on the back also looks really good. I also printed a bucket for the fish, but it came out huge compared to the scale of the boat. I also wanted there to be cleats on the front but on both the test and final prints they didn’t show up. I’m guessing that’s because it was too small but I was hoping on the bigger print they would show up. Overall I like the way it came out and I hope my dad does too
